On 1 Mar 2017 21:20, "alvinpenner" <penner@...1856...> wrote:
on Windows 10, current trunk, I normally execute the following two Cmake commands: mingw32-make -j 2 mingw32-make install
The time required for this is 300 seconds, 150 seconds for each step. This time is the same no matter how small the change, even if I just insert one single blank character somewhere. Previously, using btool, the total time required for this would be about 10 seconds or so, for a complete rebuild of Inkscape.
A complete *rebuild* of Inkscape in 10 seconds using one computer only? What are the specs of that machine?
So CMake is about 30 times slower than btool, which makes it almost impossible to do diagnostic work with Inkscape, any way of speeding it up?
Alvin
-- View this message in context: http://inkscape.13.x6.nabble. com/is-it-possible-to-speed-up-CMake-tp4979104.html Sent from the Inkscape - Dev mailing list archive at Nabble.com.
------------------------------------------------------------ ------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Inkscape-devel mailing list Inkscape-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/inkscape-devel