I just tried what you suggested, and it seems to use significantly less memory.
I had some different apps open this time, so I can't compare it exactly with my previous tests, but here is a rough comparison:
opening all files: memory percent: 7% -> 45% buffers/cache: 214 -> 435
opening and closing the previous: memory percent: 5.9% -> 27.9% buffers/cache: 231 -> 342
inkview: memory percent: 3.5% -> 21.9% buffers/cache: 226 -> 327
inkscape preview window: memory percent: 5% -> 13% buffers/cache: 337 -> 372
So just previewing the files seems to use up significantly less memory than even inkview.
On Sat, 2005-05-07 at 10:58 -0300, bulia byak wrote:
Richard, can you also try this: in the Open dialog, just select these files one by one, so that a preview of each one is shown, and see if there's a memory difference at the end. (Each preview loads and renders the entire document.) I do remember that we fixed, at least partially, the memory leaking when going through previews in this way. So what you describe may be explained by: 1) our not fixing the leaks completely, only partially, or 2) Inkscape using a different and not-yet-fixed load path when loading the document fully than when doing a preview.
Mental, can you comment?
On 5/5/05, Richard Kowalczyk <richk@...805...> wrote:
I tried doing what you suggested. I went though 26 slides, since it seemed to be enough to get an indication of the behavior.
(Just to clarify - I opened the next one (from within the current one), then closed the current one - if I had closed the current one first, the memory would be cleared)
The memory used seems to be roughly equivalent between inkscape and inkview, although inkview does use less. Either way though, the memory keeps going up as I go through more slides.
I attached three files to this email - the result of doing the command:
ps aux | grep -e "inkview" >> memory.txt; free -m >> memory.txt
for three cases:
memory_inkview.txt: after I clicked the right arrow to advance each slide, I ran the command.
memory_one_per_time.txt: I did what you suggested, and opened each file in inkscape, then closed the old one, running the command for each new file.
memory_all_open.txt: I opened each file in inkscape, but didn't close the previous file, so by the end, I had 26 files open at once. I ran the command after each file was opened.
Thanks for your help, Rich.
On Thu, 2005-05-05 at 19:38 -0300, bulia byak wrote:
On 5/5/05, Richard Kowalczyk <richk@...805...> wrote:
I will be glad to do anything else that anyone thinks will help explain the memory usage.
Can you try loading these same files in turn (i.e. closing the previous one when loading the next) into Inkscape instead of Inkview and see if there is a noticeable difference?
-- Richard Kowalczyk <richk@...805...>