Hey all,
I've just installed inkscape 0.48 from the nightly build (there is still no stable ppa) since 0.47 started crashing every time I pressed the stroke/fill dialog.
Now my presure sensitivity has gone and I was looking at the new dialog for input devices... I can't make heads nor tales of it.
What is it supposed to be letting me do? What's the difference between the configuration (which has a single checkbox and that's it) and the hardware tab? What is linking for? If the use pressure sensitivity checkbox is checked, then why doesn't it work? Is there anything else? If the testing area is for trying out all the inputs, why is it so confusing? All those little boxes? Where would pressure be shown? Why is the box so small, even when there is nothing else in that side pannel? It's hard to see everything.
I did recognise that the old input ui needed fixing, but I'm very unsure about this ui. I know what I'm doing and I can't figure it out.
Martin,