Kurt Hutchinson wrote:
On 10/21/07, Jim Ford <jaford@...2359...> wrote:
I never see entry boxes with 'width', 'height', 'start' and 'end' displayed at the same time for me to fill in precise values.
You can set the width and height when using the Selection tool. Draw your circle, set the angles, switch to the Selection tool, and set the width and height for the diameter.
The problem is that the 'height' and 'width' is of the enclosing box, which in the case of an arc isn't the diameter (try drawing a short arc and you'll see what I mean.
I've tried drawing a circle of the required diameter and adjusted the arc of the required angle to fit over it, then deleted the circle, but this is a kludge at best.
Thanks for the suggestions so far.
Jim Ford