Re: [Inkscape-user] raster to vector conversion via InkScape

Jerry Dunn wrote:

Could I get the typical trace option settings you use when tracing b/w images?

*/Horvath Andras <han@...2223...>/* wrote:

Jerry Dunn wrote:
> Yes - that worked to an extent. At least I don't have a zero length
> file now. I opened and traced, then saved to .dxf format. Opened
the
> resulting .dxf in TurboCad and I get the image but in poor
> "condition". Just bits and pieces that only hints to the
> original. I'll try working with the trace option settings and hope
> this helps. I'm dealing with mostly lB&W ine drawings so I would
think
> that they should be easy for InkScape to digest once properly
adjusted
> and tweaked.
>

Actually i could get very good results in Inkscape by tracing
bitmaps.
B&W images give the best result. Eeven at low resolutions too.

I like Inkscape and its tracing capability. Helps me a lot ;)

I hope you can get along with it.

Cheers,
Andras

Sure, i send you a source image with the traced result and the settings panel. This panel shows the default values, i did not change them.

Andras