Thanks Mark, now I have 15 objects of type Path in Layer1, when I try to union them, some of them disappear, why? I attach the file.
Javi
On 04/23/2013 03:29 PM, Mark Crutch wrote:
Hi Javi,
That is what I would expect you to see. Intersection leaves behind only the places where the paths cross each other; because you have a thin, widely spaced path on top you will be left with thin, widely spaced parts of the logo showing through.
If you look at the original tutorial again you'll notice that he uses a thicker path which densely covers the logo, to the point where very little of it shows through. The scribbled path marks the part of the logo that will remain, not the part that is removed.
If you would prefer to scribble the parts to remove, use Path > Difference rather than Intersect, though I think the original tutorial's approach is likely to give a better rubber stamp effect.
Regards,
Mark
On Tue, Apr 23, 2013 at 1:32 PM, Javier Garcia <tirengarfio@...155... mailto:tirengarfio@...155...> wrote:
Thanks, I tried what you said but I get this below after the intersection..:S. I have attached in this email the file with the two objects before doing the intersection. Javi-- Co-creator of /*The Greys*/ and /*Monsters, Inked*/ webcomics
Website http://www.peppertop.com/ Facebook http://facebook.com/TheGreysComic Twitter https://twitter.com/TheGreysComic
Try New Relic Now & We'll Send You this Cool Shirt New Relic is the only SaaS-based application performance monitoring service that delivers powerful full stack analytics. Optimize and monitor your browser, app, & servers with just a few lines of code. Try New Relic and get this awesome Nerd Life shirt! http://p.sf.net/sfu/newrelic_d2d_apr
Inkscape-user mailing list Inkscape-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/inkscape-user
